Where Can You Buy 24"H Natural Finish Wood Arrow Back Windsor Style Swivel Bar Stool
24"H Natural Finish Wood Arrow Back Windsor Style Swivel Bar Stool - RECOMMENDED TODAY| Product Code | : B000RPXHWG |
| Product Rating | :  |
| Price | : $55.00 |
Product Details
- Amazon Sales Rank: #2244374 in Home
- Color: Natural/ Natural
- Brand: AtHomeMart
Features
- 24"H Natural Finish Wood Arrow Back Windsor Style Swivel Bar Stool
- Dimensions: 18" x 17" x 41 1/4"H (Seat height 24")
- Dining and Kitchen - barstools-with-backs - Cottage Style
- Brand new in the original box. Assembly required
- Ship out within 1-2 business days. Oversize Ship Fees Included
- 24"H Natural Finish Wood Arrow Back Windsor Style Swivel Bar Stool
- Dimensions: 18" x 17" x 41 1/4"H (Seat height 24")
- Dining and Kitchen - barstools-with-backs - Cottage Style
- Brand new in the original box. Assembly required
- Ship out within 1-2 business days. Oversize Ship Fees Included
Product Description
Natural Finish Wood Arrow Back Windsor Style Bar Stool w/Swivel Seat This is a brand new Arrow Back Windsor Style Bar Stool with Swivel Seat in all Natural Finish Wood. This is a traditional Southwest style bar stool that will match any home decor setting. This is for one bar stool only. Item may require simple assembly. Dimensions: 18" x 17" x 41 1/4"H (Seat height 24")
Customer Reviews
Most helpful customer reviews
0 of 0 people found the following review helpful.
By Swim Mom
Once assembled, these are very attractive, sturdy barstools and the swivel mechanism is solid and smooth. The stools arrived with the seat/seat-back intact. The base consisted of two assembled sides (pairs of legs) with 4 spindles to go between the pairs, and the top board/swivel base that the 4 legs insert into from the bottom and the swivel mechanism attaches to the top.The assembly instructions that come with the stools would have you assemble the four legs then attach them to the top board. DO NOT try to do it in this order. The four legs all angle inward. The holes they fit into on the swivel base are all a tight fit and angle inward as well. If you assemble the legs first they will not fit into the holes on the swivel base. Start by figuring out how the two pre-assembled pairs of legs best insert the swivel base (these are still a tight fit as they angle inward as well, but with all three stools, I got this to work), partially insert them so that they can still move a bit, then fit the cross spindles between the two pairs (all upside down to this point). Once the legs are all connected, flip the base upright, place a folded up towel over the top board/swivel base, and hammer the base tightly onto the legs. From there you can proceed to attach the swivel mechanism to the swivel base (take care to make sure the the 'front' indicator is on the up-side) and then attach the seat to the swivel mechanism (upside down again for this part and rotating the base to tighten each screw into the seat through a hole in the swivel base). Please note that though there were pre-drilled starter holes for the swivel plate screws in both the base & seat, they were not large or deep enough. Either drill them out a smidge or be prepared to use a LOT of elbow grease to tighten these screws.So the assembly was NOT fun -- but the end result are some very nice barstools at a very reasonable price!
0 comments: